Drape Support Hanger

Double Backwall Hanger is used to hang two parallel drape supports in any direction on your pipe and drape display. Available for 1.5 and 2 inch diameter uprights.

Replacement rivets for adjustable drape supports. Includes 20.

Sand bag for weighing down pipe and drape bases.

Replacement button for adjustable drape supports. Includes one.

Replacement slip fit base pin for pipe and drape displays. For 1.5 inch diameter uprights. Various heights available.

Table top clamps are used to secure a pipe and drape upright to a table top.

Adjustable pipe and drape upright repair piece slips over a damaged 2 inch diameter pipe to make it functional again.

Replacement hook ends for 1.5 inch diameter drape supports. Includes two.

Clip on support rod clips to any upright to add a short sidewall or banner without the need for additional hardware. Adjustable length.

Upright conversion kit converts a 1.5 inch diameter 8 foot fixed upright to an adjustable 8 to 14 foot upright.

Drape support clamp allows for the addition of drape supports at varying heights to enhance a pipe and drape display. Fits 1.5 inch or 2 inch uprights.

Fixed upright repair piece slips over an existing 1.5 inch diameter pipe and drape upright to make the pipe functional again.

Replacement slip fit base pin for pipe and drape displays. For 2 inch diameter uprights. Various heights available.

30 pound rubber base weight for weighing down pipe and drape display bases.

20 pound rubber base weight for weighing down pipe and drape display bases.

Extend the height of your fixed pipe and drape 2 inch diameter upright by 2 feet.